Apollo CS&CL Series electric actuator

- Features-
•  Plug-in connectors for the motor, the brake option and the
heater/thermostat option
• All connectors are coded to prevent mis-wiring.
• Limit switch wires are soldered to the board - no more loose
connections.
• A six position terminal strip clearly labeled so it can be wired
up in the field without an instruction manual.
Introducing Simplicity for Calibrating Modulating
Actuators
The Control Board brings a whole new level of simplicity to the
field. It will work with either of the Motor Boards (115VAC or
230VAC). Features include:
•  Switch selector for 4-20mA or 0-10VDC input
• Switch selector for 4-20mA or 0-10VDC position readback
• Switch selector for either “fail in-place” or “fail to zero” upon
loss of control signal (provided input power remains)
• On-board push buttons to manually position the actuator
• An adjustable pot for Speed Control (motor pulsing)
• An adjustable pot for deadband adjustment
• A “Mode Selector” switch with LEDs, which are used for:
• ”No tools” pot calibration
• Setting Zero and Span
• Manually positioning the actuator
•  Locked Rotor Protection if the actuator cannot achieve the
position commanded by the control signal, it will cut power to
the motor. Repeated stalls will not damage the actuator.
•  Reverse acting operation with no rewiring.
• Split range operation with no rewiring.

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: