Extruded Linear Thruster

The Bimba Extruded Linear Thruster is a rugged, guided actuator with a cylinder integral to the thruster block.  The sleek body incorporates switch mounting, for a clean, space-efficient package.  As strokes increase, distance between the guide shaft bearings also increase.  For ET and ETD models, the maximum side load stays constant regardless of the stroke specified.

• Standard U.S. customary (inch) threads for ports, mounting, and rods
• Bore sizes: 12mm, 16mm, 20mm, 25mm, 32mm
• Maximum operating pressure is 140 psi (10 bar)
• Expected service life stretches to 1,500 miles (with filtered, lubricated air)
• Temperature range is 15°F to 160°F (-10°C to 70°C)
• PTFE grease used for cylinder lubrication

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: